DMSO

TLW Methods for Life-Threatening Diseases Using DMSO

Published

on

Regarding life-threatening situations the goal would be to more quickly get TLW circulating in the blood while trying to stay under the nausea barrier.

One way to achieve this is by adding DMSO to the activated TLW so that it can act as a carrier for sending TLW directly into the skin and muscles of the body and thus into the blood of the body.

Experience and testing has proved that DMSO is carried directly to any cancer in the body and it then penetrates the cells of the cancer. This is not theory, but has been proved through testing. In this case when the DMSO is carrying TLW the theory is that it will carry the TLW into the cancerous cells killing the virus that causes the cell to be cancerous.

That part is, of course, theory. However, many cancers have been cured as many people have phoned me so stating that their cancer is gone.

WARNING: Do This Test First:
A few people are allergic to DMSO or have very weak livers and can have bad problems with DMSO. Wash your arm carefully and dry it. Then add one drop of DMSO to one spot on your arm and rub it in. Give it about 15 minutes to soak in and then wait several hours. If there is no pain in your liver area you are probably safe in using DMSO which will be the case in 99 people out of 100. To be safe, wait another 24 hours to make sure there is nonreaction to the DMSO.

In this case, I found by testing that after three minutes of stirring the TLW and the acid as is normal, the DMSO should be added to the mix immediately without further delay. Otherwise much of the power of the TLW is wasted or lost. I suggest stirring the activated TLW with the DMSO for only 15 seconds. Then immediately rub it onto a large area of the body like a leg or arm. This may get as much as 5 times more TLW through the skin and into the blood stream. And of course, using a larger area of the body can also get more TLW into the blood stream.

Taking TLW as described below is an accelerated skin treatment technique that pushes TLW into the plasma of the blood in addition to the normal oral doses of TLW . Exact steps follow:

1. Make a dose of TLW by activating 10 drops of TLW with 50 drops of lemon juice or 10% citric acid. Swirl or stir it for several seconds and wait for 3 minutes.

2. Add one teaspoon of DMSO and stir it for about 15 seconds, no longer.

3. Immediately rub it on to a leg or arm or belly. Do not wait any time at all as the solution is quickly losing strength as time passes. For example, a three minute wait would be too long.

You can use a plastic sack with your hand inside to rub the solution onto your body, or you can just use a bare hand or hands. If you noticing any burning sensation you can add a teaspoon full of water to the area that is burning and rub it in. Keep that up until there is no more burning. You can rub olive oil and aloe vera juice on the skin after the application. Use a different part of the body each time you apply the TLW/DMSOr.

4. Do this once every other hour the first day, and once every hour the second day, and third day, and then quit for 4 days and start the same thing the next week, but never stop taking the TLW by mouth.

DMSO is a well-known carrier substance used widely by doctors since 1955 as a way to carry medications directly into the skin. It is available in drugstores in most states, and also on the Internet. Do a search for DMSO.

Trending

Exit mobile version